I know the printhead moves to the side for timelapse even though I’m not recording, but my new A1 pauses, moves the bed forward likes it’s going to stop printing, the printhead moves to the left and goes down all the way, then goes back to printing. This only takes a few seconds but it seems long enough to produce banding on my taller prints. My old A1 does not do this. Both are running the exact same gcode file. Is anybody else seeing this and is there a way to fix it?
1 Like
Is clump detection turned on?
“After printing more than 3 layers, the nozzle clumping detection is performed for every 8g of filament consumed.”
1 Like
Ugh this must be it. I’ll turn it off. Thank you!