Hi had a new update for the A1 today
Ver 01.02.02.00
Any idea what this one does for improvement?
Cheers
Bambu studio / device / update / release notes
1 Like
This is a way back! There was a beta firmware with a lot of great changes and now its overwritten with almost the contents of the last firmware level 
https://wiki.bambulab.com/en/a1/manual/a1-firmware-release-history
A1 version 01.02.02.00 (20240515)
Improvement
- Improved printing stability.
And that is all there is…
it made my A1 almost unusable the fan doesn’t ramp up anymore when bridging across infill sags leaving the top layer looking bad around the bottom is a lip about 5mm up where the added upwards rim stocks out I don’t know it the side can be seen in this photo (not a very good camera)
It didn’t fix the filament change screen randomly picking the type of filament from whatever I set it to something I never use each time I go to change the colour. Forcing me to set the type back each and every time.
Same problem with the A1 mini.
1 Like
It seemed like the bed leveling might be a bit smarter and only sample a grid of points around where the model is actually going to be on the bed.
1 Like