I recently purchased a second X1C. This newer printer is showing an annoying behavior not seen with the older unit. This newer printer has two AMS 1 units attached. When I start up the printer from power on all eight of the AMS stations initialize and the LED at each station shines steady white. After a print job the control panel hangs at the dialog waiting for confirmation that the job was good. All eight AMS stations show red flashing LED indicators. This is very problematic because in Bambu Studio the Devices tab for this printer fails to show that there are loaded AMS slots available for filament selection on the next print setup.
So far I have had to cycle the power on the X1C to clear out this issue so I can start another print job. How can I correct this behavior? My older X1C never does this. The AMS selections on that machine consistently stay available in Bambu Studio from print job to print job.