Next Printer X1 Carbon or the X1E?

[simon14]

@FireMedic541

I wish they would allow us the ability to upgrade X1C to the X1E for chamber heat control and >300c nozzle temp, among others. It can’t be all that difficult; 2 additional boards, the heater unit, Extruder PID and some adapted firmware. A lot of us would go that route should they allow it.

@simon14

x1e = x1c + RJ45 port + chamber heater + slightly better hotend

x1c = $1300
x1e = $2800

I don’t think they would give up profit over $1000 for parts that cost about $400