24 hours in…I forgot to scrape test line at front of build plate, then I sent another print. The nozzle got hung up on test line still on plate, scraped into my build plate pretty badly.
I wanted to inspect the nozzle and replace, ended up in this mess. Please tell me I’m not cooked!
PETG Basic hanging out there.
Cut the filament? <25chrcaters/>
I’ve done this 1000 times, and it tends to just do another line slightly offset to the original…
There is no way this would cause the nozzle to crash. The carriage is WAY too stiff.
It honestly sounds like the nozzle was not installed 100%.
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.
