Nozzle tapping printbed during bedlevel procedure

Bambu Lab X Series Bambu Lab X1C
1

Who can help me out on this:

Just got my new X1 carbon in yesterday and setup all but…

My nozzle is tapping the printbed while doing the bedlevel procedure att all the measure points.
I do not think this i right and I am not daring printing as long as this problem is there.

It makes a tapping sound at each point where it measures when hitting the plate.

I have textured PEI plate

2

That’s how bed levelling is done. There are 3 piezo sensors on the bed and they are used for levelling hence the tapping at each location.

6 Likes
3

thank you, (first time using bambu lab)

4

I think I had watched enough review videos to not be surprised by the tip touching the table

1 Like