P1S - Multiple Hardware Issues?

Bambu Lab P Series Troubleshooting
1

Hi all,

Got these two warnings, the motor one a few days ago (thought it was printing okay) and now the nozzle tempature, causing a print to stop entirely. Turned off the printer to avoid any further issues.

Before going through the steps and potentially purchasing replacements, is this a potential circuit board issue of so sort? I’m surprised both popped up so closely together and are (at least from what I can tell) unrelated.

image
image1017×193 4.88 KB

If multiple failures like this are just (likely) coincidence, I’ll start going through the tests suggested, once I can get my printer moved.

1 Like
2

Both errors sound like something which could be caused by a bad connection. I’d be surprised if both the B motor and the temperature sensor would be on the same connector though…

3

Right? I’m hoping that’s the issue though and maybe happened around the same time, for whatever reason. I’ll try to check the connections through the steps tonight and see what I find. Thanks for the thought!

1 Like