Well, that was quicker than expected. Despite Fedex literally tossing it on my porch (on its side ignoring the this-side-up sticker), it worked perfectly out of the box. A scraper first, then a desiccant box that looks absolutely perfect.
Anyway…
In a 30 minute print the temperature probe I added only reached 34C doors closed, set for basic PLA. I have to run out this evening so did not want to start anything long.
I need to look up what the desirable chamber temperatures are for different media (unless someone has it handy), but the bigger question – is the probe location a good place to check temperature for the chamber? If not, suggestions?
And yes I need to clean up the wire, but that’s for later.
