For me the biggest problem is that the message I get is ambiguous:
“Build plate localization marker is not found, or the current build plate is not the same as in G-code. Please stop the print job and replace the build plate. You can also tap “Resume” to force resuming the print job. [0300 8006 093010]”
I think it should be split into (something like):
“Build plate localization marker is not found. {%EXPECTED_PLATE_TYPE%} was expected. Please stop the print job and replace the build plate. You can also tap “Resume” to force resuming the print job. [0300 8006 ######]”
and
“Build plate localization marker {%DETECTED_PLATE_TYPE%} was found while {%EXPECTED_PLATE_TYPE%} was expected. Please stop the print job and replace the build plate. You can also tap “Resume” to force resuming the print job. [0300 8006 ######]”
This way when I stand in front of my printer I instantly know if it is fine to continue and don’t have to check in my slicer again if I selected the wrong plate.
I get the message every now and then when the room is (too)bright.