ok,
The filament is Elegoo, PLA, Tangerine, new
Screenshot of settings:
The product I am printing is a rack to hold my wife’s leather tools. I could give you the file name if you need it, from Thingaverse.
I have videos of the print in action, this one in particular shows the first layer printing, and you can see at time:3:23, the print begins to skip lines etc. at about the mid point.
It is pretty long, so I didn’t load it here, but if you want…I can.
As I said before, the same stl file, the same roll of filament the same settings in studio, prints perfectly on my P1S
Is it OK to reset the printer to factory settings from the screen?
Is there another updated firmware that is safe to download, even though Studio says that V01.07.05.00 is the latest?