Power consumption data

Bambu Lab X1 Series
50

I have an 900VA UPS with smart plugs on output and the data I’ve collected is:

  • when in stand-by mode it stays between 7.9W and 8,5W with chamber lamp on, or between 6.7W and 7.2W with chamber lamp off
  • when starting a print with 2 AMS attached it gets above 900W for about 20 second when heating the bed. But its consumption never exceeds 950W at which point my UPS should start playing an alarm.
  • during a print the consumption varies but it’s slighly above 130W