In PrusaSlic3r there is a popup which indicates printing issues after slicing, such as overhangs etc. Is there such a thing in B.Studio?
I was comparing a print that had clear issues with overhangs which P.Slic3r picked up but B.Studio just says “all good”. ???
Yes, similar warnings exist in Bambu studio. Bambu studio is based on Prusa Slicer, they are more similar than you would think.
Bambu studio is more lenient to what it will pass since it assumes a best case scenario and is more finely tuned to each printer.
Yes, after reviewing a few more models that was def the impression I was getting as well.
Thanks