When printing ABS, I tend to heat up the chamber to 50° using the Aux fan and bed temp at 110°.
A single print I do will usually take about 1h50m. I clean the bed and immediately try to run a 2nd print.
This time around, the slicer (Bambu or Orca) will have a hard time connecting to the printer. The results will usually be connection drop outs or no connection at all. I cannot send the print job to the printer.
Before printing ABS, I isolated the electronics and added a 2nd Noctua fan to exhaust any hot air from the MC board, but this doesn’t seem to help.
I’m using the latest firmware for the X1C.
Any thoughts on what is going on?