I printed a plant box, as shown in the attached image. On the front, there’s a step on the lower white section, and on the back, there’s a similar step but on the upper white section. I also noticed that the surface along the X-axis is not as smooth as along the Y-axis. The filament was dried and th…

Those bulges are likely a result of the scarf seam. So far, there’s no magic to fully eliminate the seam that I am aware of, but extending the scarf around the entire wall (there’s a simple checkbox for that) and using the seam painting tool to have it only one side may improve things though. As fo…

Thanks for your answer. Here are more images to see what I mean. Along the x axis they are vertical „shadows“. On the y axis (smaller width) it so perfect for me. So why that happens. Of course I can check the belt but the printer is 2 month old with just 5 prints. Is the any settings on bambu stud…

I am afraid that it does look like VFA’s. No (easy and) reliable solution as of yet. [image] Persistent 2mm VFAs on X-axis Troubleshooting Because I have been printing translucent objects whose cosmetic appearance I finally realized just how bad my VFAs are and I’ve been p…

I have also found raising the nozzle temps to 204 over 220 has made cleaner prints with less stringing. My first few PETG prints looked like it was covered in spider webs.

Printing PETG not correct

Bambu Lab P Series Troubleshooting

EnoTheThracian August 21, 2025, 7:52pm 4

I am afraid that it does look like VFA’s. No (easy and) reliable solution as of yet.

But you should tighten the belts regardless. The machine can get quite a few shocks during transport, so if you haven’t done it yet, it would be prudent.