Problem printing large flat tile

Bambu Lab P1 Series Troubleshooting
5

Do this.

  1. Go to Nano Polymer Adhesive – Vision Miner

  2. Add a 50 or 120ml bottle to your cart

  3. Hit order

  4. Go over to Amazon and order https://a.co/d/dwHzQRn

  5. Heat the build plate up. I do 50c then put some on the plate use the foam brush you spread it out it will flash off fast.

  6. Enjoy It’s unmatched bed adhesion and ease of removal when the buid plate is cold.

For stuff other then the higher temp fillaments example Nylon, PC, PPS etc you can get a lot of prints before you need to reapply.

Even if you don’t use it every print. This is your tactic nuke against weak bed adhesion and way too much bed adhesion with stuff like TPU. This stuff is by fast the best build plate prep you can get. Second place is not even remotely close this would be a Koenigsegg Jesko absolute. Second place is a 2008 base model Chevy Cruze. But seriously once you try this you will love it. And this phrase gets used for pretty much anything in 3D printing because people just overuse it for anything. With this literally was a game changer for 3D printing. Anyone who’s printed PEEK we’ll tell you that this stuff is basically a miracle on a bottle.