Hi all,
I used to print with the old version of Bambu Lab Support for PLA, and it worked flawlessly. However, when I restocked recently, it was out of stock everywhere, so I decided to try the Support for PLA/PETG, assuming it would behave similarly. Unfortunately, it has been a nightmare.
The Support for PLA/PETG doesn’t adhere well to PLA, the print quality is poor, and sometimes the print fails entirely. I even tried drying the filament, but it didn’t improve the results.
Has anyone else experienced the same issue? If so, I might just remove this material from my options in the future. And I am also wondering how is the new version of Support for PLA, does it have as good performance as the old version?