Hello, I have printed the following file from makerworld with the supplied settings.
however, the print has a few problems:
Printer: A1
Nozzle: 0.4mm stainless
Filament: Bambu PLA basic
https://makerworld.com/en/models/252373?from=search#profileId-268741
some corners lift up from the bed.
one side lifted up and is now horribly distorted. I suspect that the nozzle hits the part.
some of the ironing surfaces show defects.
what causes these problems?
How can I avoid these. I tried printing some animal models with low layer height and ran into the problem of the nozzle hitting the print.
prints with 0.2 I have no problems.
