Bambu Lab Community Forum

Project: Thermal and Noise Kit - P1S and X1C Upgrade

Bambu Lab P1 Series User Mods

simon14 December 16, 2024, 9:44am 4

Very nice pattern there.

My setup

DIY Fume extraction for P1S questions and probably pics when finished User Mods

I suggest you make an insulated enclosure for your printer. It serves two purpose: stabilizing chamber temp for ABS printing and keeping bad particles from spreading into the room. Then upgrade it with 2 air ducts to bring fresh air in and take bad fume out after the print. Say, run air circulation for 30 minutes after print should mostly eliminate most of bad particle in the enclosure. I am glad I went this route while trying print ABS with bed slinger Anycubic i3. [20241203_040404] [2024…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled