I updated Bambu Studio to version 2.0.2.57 last night, and it no longer lets me select PETG, only PLA appears as an option. It’s possible I’m overlooking something, as the UI seems to have changed.
Hopefully someone else will have some thoughts. Still new to this myself, but I also did the update and Studio seems to hang now for about 30 seconds when I select the materials options.
1 Like
I just installed version 2.0.2.57 a couple of hours ago. The first time I fired it up, it asked me if I wanted to sync something or other (I don’t recall). But after I did, all my previous filaments appeared, and I was set to go. I’m printing a TPU funnel cap right now.
I’m kinda diggin’ the new UI. 
Darn it! The previous version was already functioning well with PETG, why change it? 
I had to downgrade to v02.00.00.95 to be able to use PETG again.
The new version is completely screwed up concerning PETG. The temps are all wrong, and if you reprint a PETG model from cache it shows PLA as your only option. I too went right back to the previous version, I don’t even like all the UI changes they made anyway. 