This is v.2.2.0.85, but it was also happening with v.2.0.3.54.
Current X1C Firmware version: 1.10.00.00.
As stated in An interesting crashing occurring - vase mode?, every time I open Bambu Studio (from either clicking on a model to open BS or clicking on the BS shortcut), I get an information screen asking me to select Yes or No to the following:
Spiral mode only works when wall loops is 1, support is disabled, top shell layers is 0, sparse infill density is 0, timelapse type is traditional and smoothing wall speed in z direction is false.
Change these settings automatically?
Yes - Change these settings and enable spiral/vase mode automatically No - Cancel enabling spiral mode
Whether I select either Yes or No, BS crashes within 2 seconds and if I do not select anything, the message regarding Vase mode stays on the screen, but BS crashes after about 3-4 seconds.