I am new to 3D printing. Currently, I am planning to use the rest of my Creality PETG to print part of the AMS riser. However, after slicing, I found out that I am about 50g short of the required material. Is it okay to put Bambu PETG in AMS directly after the refill reminder, or is it better to cut the model into two parts and print the last part with Bambu PETG?
I’ve mixed EleGoo PETG Rapid with other brands without an issue. That said with most of these type of questions the best plan is to print a small test print becasue there are so many brands you the combinations make it almost impossible to predict every combination.