I have not printed in the X1 for some months (been in Uganda). Today let it upgrade before started (I think my first PETG) print. When checking the (my experience flawless X1) print, the nozzle is parked and in the AMS there is a lot of filament not rewinded.
Anyone got the same experience?
downgrade to previous firmware and try again
Make sure you have a correct spool in the ams some of the plastic spools are to thin for the rollers to wind it up and cardboard spools shouldnt be used.
Update: Fourth time, I I pulled the filament half an inch back, pushed it back down and… the print resumed
I replied previous post, showed up as a reply as well as a new post. Deleted the new post
Too similar to recent post, banned by moderator. Seriously? Why post my replies as new post? I don’t get it. I replied previous post, showed up as a reply as well as a new post. Deleted the new post
1 Like
Don’t worry. Sh1t happens. Be happy. You replied above
drakko… youv’e been around : ) I am new to switching to MakerWorld. Thingiverse, been there since the start. Switched to Prusa 3D model site, done with that. Now a MakerWorld’er (will this my reply also post as a new post?)
I hit “Reply” on your post
Enough already. Stop posting my texts as both replies as well as new post. Nobody else forum does it