I have realized some bad print surface caused by “G3 Z xxxx” commands in GCode created by BambuStudio.
When removing this line manually in GCode the print surface is great but working with GCode is not very comforable because i can only use it with SD card.
This command is somehow not needed and i could not find any settings to avoid this. Also in machien gcode section i could not find it.
How to avoid that “S3 Zxxx” command is used BambuStudio?
Thanks for the answer. But i already tried this before and it was not solving the issue.
I have found somehow solution by disabling wipe and retract in printer settings.
Afterwards the arc move (G3) is no longer in the GCode and the surface quality now is much better.
Oh, I see. I thought you were only trying to disable the Arc moves.
It’s performing spiral wipes because you’re in Z Hop auto mode, and some filaments don’t respond well to that. To fix this, you can enter custom settings for this filament in your filament overrides - either switch it to normal mode or turn off the wipes completely if they’re unnecessary for your filament type.
