I’ve printed a few toolbox desktop organisers created by Mrtk1970 on Makerworld. I’ve tried printing the inlay in PETG because I think this part should be more durable since keys, coins etc may be thrown in here, but I’m getting very poor results with a very rough internal surface and lots of zits.
The material is Bambu PETG HF and I dried as suggested for 8hrs. You can see from the photos that I did get some improvement with the white after drying for an additional 10hrs, but still not great.
I have just noticed that the speed view on the slicer seems to show that each layer isn’t printed at a consistent speed, and it may vary from 103 - 154 mm/s. Could this be the cause of my issue?
Printing with a P1S
Printing with default PETG HF settings
Bambu PETG HF black and white spools. Both dried fro 8hrs at 65 degrees. White was dried for an additional 10hrs
Toolbox inlay_stron_3mf.3mf (2.6 MB)