Speculation about new printer announcements

[JayZay]

and you may be correct (not sure about copoennt lfierime):

Best practices for thermal insulation? Maximum chamber temperature?

Little pink houses. That was fun. My kiln certainly works ! It just kept climbing. Even with no back, I hit 77 degrees C on the panel for chamber temp. All openings taped and the chute stuffed and taped. and it was still going up when I hit the brakes. Probably not worth a bit of print flexibility but illuminating anyways. I will likely use it, but put on at the last minutes of print to slow cooldown only. [1] [2] [3]

77C will make a difference.