after the error that the filament got stuck on the nozzle or that the plate was misaligned, the printer started to stop in the middle of the model and just stand for a minute, then it continued to print, but not for long, and after a couple of seconds, it stopped again.
This happened on my P1S on a print once.
I cancelled the print, rebooted.
I haven’t had the problem since.
Sometimes a bit in the matrix becomes flipped.
1 Like
i turned the printer on and off with the button then i clicked continue printing the printer was standing for 5 minutes without doing anything and then it continued printing
i don’t know what it was..
1 Like