Hello everyone. I actually just want to make simple pots for my plants, so that the pots look a bit nicer they have a radius at the bottom, which has a 40 degree chamfer towards the bottom so that the overhang is not too huge. But whenever I print them, they get a strange edge in the middle of the r…

Try some of these suggestions [image] Remove mysterious blobs on outer wall Troubleshooting SOLVED! Circling back to you guys, I’ve done the following. After contacting a construction engineer, he said this [freely translated]: The cause of the blobs is the flat top su…

The reason for this edge is the shrinking of the “heavy” bottom, which contains much more filament. This filament is shrinking more than the walls of the pot. This was also discussed in this thread: https://forum.bambulab.com/t/not-sure-what-this-is-called-invert-of-elephants-foot/

Ah wow, thanks for the quick reply! But no suitable solution has been found yet? Do you think it would help to use as little infill, floor and ceiling layers as possible?

The best would be to change the design, but you also play with cooling. In the thread are some options mentioned.

I’m struggling with this issue too @SimEyeSee . Before I go into f360 and mess with my model, could you clarify something for me please? When you say “3. Concave in the base” do you mean concave the top surface of the base? Am I right in thinking that you just make the top surface of the base not fl…

Gave it a shot and can confirm that simply making the top surface of the base curved/concaved solves the problem. Thanks for figuring it out!

Perhaps this will help someone else here :smiley: [image] Remove mysterious blobs on outer wall Troubleshooting I have now done some testing. Option 1 seems rather difficult for me to implement in Orcaslicer or BambuStudio. Options 2 and 3 have given me the best results.…

Strange edge in the radius

Bambu Lab Software Bambu Studio

Gia3dp June 11, 2024, 8:11am 9

Perhaps this will help someone else here