Hello Bambu forum.
Running Bambu Studio v2.6.0.51 on my old Dell laptop, Computer 1 for many months with good results. Got new Dell Laptop, Computer 2, and installed Studio v 2.7.1.52
Could not connect to Bambu H2S. When I clicked Print Studio returned “Not satisfied with the grouping of filaments? Regroup and slice.”
Some research at this excellent forum and other sites .
”Why 2.7.1.62 breaks H2S connections
Users report:
-
Printer not appearing in Device List
-
“Bind with PIN / Access Code” loop
-
LAN Mode not detecting printer
-
Cloud account not syncing devices
These issues disappear immediately after downgrading.”
So 2.7 was uninstalled and replace with 2.6.
After the install of 2.6 I was able to select H2S as my printer.
But when I went to print the same message “Not satisfied with the grouping of filaments? Regroup and slice.”
Has anybody received this message. If so were you able to solve it?
Thanks.
Allen Pitts
Dallas TX