Technical: filament and pressure advance settings

[DeVerm]

and here are the links to post with settings that work:

Polylite PETG profile anyone?

Just in the middle of tweaking profile for it. So far changes I did are following: bed temp: 75 nozzle temp: 265 (first layer 255) flow ratio: 0.93 density: 1.25 min fan speed: 0 (layer time: 20) max fan speed: 20 (layer time: 6) AUX fan speed: 90 filament start G code: M106 P3 S255 Currently tweaking PA and max volumetric speed, so you will have to wait couple of h.

and

Polylite PETG profile anyone?

The problem with AUX fan (compared to part fan) is that it is fixed in position and direction. I just had a larger print that failed, because part has warped (detached from the bed) - it became too cold in one side of the bed. So, AUX fan is something that you won’t be able to fix to certain value but perhaps adjust considering the print size, orientation. Regarding brands of filaments, I have tested so far. Almost same settings (temp 265, aux on, part fan low, all have around 0.05 PA and max…