I just wanted to post about my experiences with Tinmorry Filaments and my P1S.
So far I have used PETG-GF, PETG-CF and PET-CF, they are all significantly cheaper than Bambu Filaments and available next day on Amazon, at least in the UK.
The quality that I have got from using them has been as good and in the case of the PET-CF better than the Bambu version.
There range is not as expansive in terms of material type and colours but if they have what you need, I can fully recommend them.
The next one I am going to try for a car project is their PAHT-CF.
They work in the AMS, never had a breakage and as long as you are happy with the extra wear on PTFE tubes and gears, they work well.
Tinmorry’s Black PETG-CF is one of my favorite of all time. Prints beautifully, very strong, reliably comes dry (so far!), and won’t break the bank.
I’ve used one of their PLA-CF as well, solely for aesthetic. They have a muddy-red colored one that prints up looking like some sort of terra-cotta modeling clay. Its quite nice.
I appreciate posts like this; while I’ve been very happy with Bambu filaments, the cost and the time to deliver them doesn’t match the convenience of just grabbing something from Amazon that gets delivered in a matter of hours. I’ve tried eSun, Elegoo, and Sunlu filaments from there and they’re all good, but I’ve stayed away from the cheaper ones. These look like an absolute bargain, so if they’re good, that’s superb!