Thank you very much for your reply,
I changed the original microSD two or three months ago, with this one in the photo that I attach.
Normally I format it with a program called (HDD Low Level Format Tool) that does low-level formatting.
Then after inserting it into the printer I format it directly from the printer (to be sure that it is formatted in the correct format)
In your opinion, do I have to change it again?
In your opinion, can we rule out a problem with BambuStudio because I cut a model that had already been cut previously?
Luckily the tip of the nozzle did not touch anything in Z… at a certain point there was only the X and Y movement that caused the ToolHead to hit the front right corner.
PS: when I do the total calibration of the printer, are the detected data saved on the MicroSD? If I format the microSD do I have to redo the total calibration?
Thanks and sorry for the many questions…