Yes, I did a total post-crash calibration, and then I tried to print a BambuCube 30x30x30mm and everything went well.
With “Pc simulate Gcode” I meant that I tried to simulate the printer’s movements in Bambustudio with “travel movement” turned on but I didn’t find anything abnormal…
Before starting the print I checked to select P1s as the machine and I set my custom work profile for a layer height of 0.2mm. (as I always do every time I download a model from makerworld)
and then the problem occurred after it printed up to a height of 11mm in Z
Do you think it could be because I cut a model again that had already been cut once before?