TPU printing success

Bambu Lab P Series General Discussions
1

Hey, Just a quick question/poll:
What’s the softest TPU you guys have printed on the P1S/P1P and what speed did you manage to get to?

I just ran out of 95A HF from bambu, and while looking for some more TPU I found stuff as soft as 82A, but I’m not sure if the printer can handle it at a reasonable speed. Most of them state a speed of below 70mm/s and I’m hoping to get something like 100 or more from it.

If you had print failures with these soft materials, what did you do to fix them if anything?

2

I printed fine 95A and 90A, for 90A I just raised the temp because some clogging

3

85a , without problems on p1s
I first printed it out of a creality drying box. that needed a higher flowrate because of the friction inside the long way through the tubes.
now I use an external spoolholder with bearings and almost zero friction.- so i had to reduce the flowrate dramatically.( I still enter the outcoming pftg tube)