Hi all, new to MakerWorld so forgive me if this is an obvious answer but I can’t workout how to upload multiple print profiles, I have one for two colors without AMS and one with AMS but can only see how to upload one profile so I’m obviously missing something 
Any advise would be welcome thanks…
After uploading your model with one profile you can add extra profiles on the model page
That’s great, thanks for the prompt reply, much appreciated 
1 Like
I have been kinda wanting options to upload more than one before publishing. It’d be nicer to not have to wait for verification, then upload profiles and wait for those to verify. Sometimes verification takes a while. Took 30+ minutes once, and I had multiple other profiles I was trying to upload. @Tanklet?
1 Like
I think that’s why I couldn’t find how to do it, it seems a strange way to go about it
1 Like
@Zammer3D @Ideas_Unlimited
One way for this is to upload a model with just STL, it will pass verification in less than 1 minute.
Then upload profiles one by one and you do not need to wait the completion of previous one.
2 Likes