I think 28c should be just fine for printing PLA.
I use the Textured PEI plate for most of my PLA prints, I use Aquanet hair spray on the PEI plate for prints that I suspect might have adhesion issues and that works well for me.
I find it easier to apply than the glue stick. When the textured plate cools down fully some of my PLA prints release completely from the plate and some just need a little flex of the plate to release.
I printed the DK Riser from Makerworld ( DK Riser for BambuLab X1 by papsjundi - MakerWorld ) I open the vents when I print PLA but I leave the door closed
and the top glass installed. The LED lights in the riser (set to 10% brightness) make it much easier to see inside the printer through the door and the top.
I moved my AMS to a wall mount to the side of the printer because I like to be able to easily remove the top glass for Hot end swaps and maintenance.