Weird issue with first layers and Bambu PLA Wood

Bambu Lab P1 Series Troubleshooting
1

Hello! I had an issue with printing enclosures for my D&D players using PLA wood. Attached is a photo. It looks like the initial layer was scratched all over… I would appreciate any suggestions and advise. Here are the details:

  • Bambu P1S with AMS
  • Bambu PLA wood (the humidity inside the AMS is 10%)
  • Textured PEI plate (I normally clean it after every print with IPA)
  • Printed using a 0.4 nozzle with the standard 0.2mm standard profile
  • 15% infill and gyroid infill pattern

IMG_7947
IMG_79471920×2560 786 KB

2

It is crazing in plastic

4 Likes
3

Thank you for explaining this! :slight_smile:

4

Thanks! That did solve the issue, appreciate the explanation :slightly_smiling_face:

5

This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.