Second new printer out of four that I got from them have hotend fan failures. First was an H2D that felt like major freakin surgery to replace, now I have a new H2S doing the same thing.
Seriously. They REALLY need to stop using cheap $%^& fans in these things. This is beyond annoying, especially considering the absolutely moronic tardhammer that designed a part that could easily fail, and have it nested and wrapped in 947 different micro-cables where screwing up any one of them could cause you to damage things even further.
I’m just seriously annoyed and venting. Their QC blows more than their fans do….
AND to top it off, I’m in the middle of a fairly large print and have to keep telling it to keep going when it errors because I can’t open a ticket and make it download the logs until the printer is idle. Cant do it if it’s paused, either.
$1 says they’re vibe-coding everything…. grrrr……
If they were vibe coding they’d actually release updates with something approaching reasonable speed.
Their dev team is clearly small and they aren’t staffing up to meet the demand of all the products they’ve released.
1 Like
Oh if they were vibe coding they might release updates faster, but they all would be total crap.
Oh. Wait. Nevermind. 
The parts they make or buy are very cheap and the qc is horrible. So why does everyone buy these printers. I bought Flasforge and they print great when they work, that is when they work! Their POS extruders will pull a 5KG spool, not Bambu. Tried to get a jam out of my AMS and the cheap connector breaks off now I am down for 2 weeks….. Why did I buy this extremely expensive printer again?
1 Like