Yeah it happened overnight and I just have the aftermath (AI paused it). I wonder if the right ones where the bed is hotter resisted falling over despite the ooze dragging on them due to better bed adhesion or it was just chance. I wouldn’t read too much into this haha.
The vent-like things on the left is an air filter to get rid of the PLA smell and just additional filtration for materials that print in heating mode. I work in a small space with kids around and it helps a lot with the smell. I think I can get rid of the remaining printing smells with A covered poop chute/catcher. Very happy I can print all the things in my office without a janky contraption to duct out of a partially open window! Not to hijack this thread, the discussion is here H2D Air Filtration Upgrade - #63 by KYZ_Design