Why is Factor K now stored in the AMS, not filament settings?

[NeverDie]

Good news! I found out there’s an even better solution now, using the H2D automatic calibration prior to launching a print, that arguably far better in the H2D than whatever came before in any of the other Bambulab printers. Details and further explanation here:

Auto flow rate calibration is gone?

There will almost always be some level of jitter, but it’s also important to keep in mind that even manual calibration can drift over time. For example, if the filament was calibrated before drying, and then dried and printed afterward, the results may differ slightly. Variations can also occur between different colors or filament batches. Several factors can influence calibration and print results, so having an automated algorithm run before each print can help maintain consistency and get re…