I made a video about the recommended maintenance for the X and P series 3D printers:
These recommendations come from the official wiki: Bambu Lab X1 Maintenance Recommendation | Bambu Lab Wiki.
Note to hold your fans and not let them spin while cleaning them out. I rightfully got called out in the comments many times. I’m sure Bambu Lab put some reverse voltage protection on their PCB or a free wheeling diode but just to be safe don’t let the fans spin.
Hi 3D_Print_Stuff, thanks for sharing.
This article has been listed on our Wiki. Please check it out here:
https://wiki.bambulab.com/en/admin/contribution-guide
Congratulations on obtaining our “Community Contributor” badge and two rolls of Bambu Lab PLA filaments.
This is a great video but u didn’t do the fillerment sensor change out and y it needs to be done
P1 tensioning wiki article:
Recommend adding pictures or link to the sections with pictures of, said tension screws.
Nest procedure with P1 as well, not just X1, which causes confusion. Just look at reddit and the people thinking there’s no procedure for belt tensioning on the P1.
Just a few minor recommendations. This guide could be so much better, but with the inability to utilize the built-in comments section to leave feedback means you’re going to get far less feedback and your guides/wiki will continue to suffer for it.The two suggestion above are a simple start, things I’d expect to see at the very least, but as I said, there’s quite a bit with this one little guide that could make it so much better. I don’t even want to look at any other guides in the wiki. As a technical guide writer, it’s making me mental.