I noticed that after every few prints the bed didn’t completely level and was wondering why. Finally I saw that the right bearing was coming out of it’s place. To fix, I had to raise the bed all the way up, then turn the machinje upside down and give a few hard taps on it, so the bearing would slide in again, till the next time. I don’t think this will be a good thing in the end. Couldn’t find any debris behind it, unless it hides even deeper somewhere
The debris is usually in the pockets in the base that provide clearance for the bearings.
Yes, cleaned that again, but there was not much in there. Keeping my eyes on it.