Thanks folks for letting me contribute,
I have started printing in PETG but the stringing is driving me to drink. So i have been thinking, i will drive out the moisture in the filament, and put it in racks with Selica Gel and instal it in boxes that are sell at IP55 specs. From there i will pipe it to the Ams lite motors and to the printer without mounting it on the AMS lite. To fool the AMS i will install old reels with a meter of filament on it that does not go anywhere.
This way the filament will remain dry, hopefully.
Question is, do i need to fool the AMS or ignore it???
This may interest you.