i have the ams and a1 mini together for 4 days, almost every single print I start off with errors, “failed to pull back filament” or “please check if spool is stuck” or “failed to extrude” etc yet theres no issues! if i dont use ams and just use the single spool theres no problem. Can any one help. after sending the A1 back and getting this set up, and with the ams not working as it should, im thinking about returning the whole lot and going with another manufacturer.
Have you updated to the latest firmware?
My A1 used to have loads of weird nonsensical errors out of the box until I updated the firmware.