A1 mini non original bambu build plates not detected anymore

Bambu Lab A Series Bambu Lab A1 mini
1

Since the last firmware update my non Bambu build plates are flagging the build plate not detected warning. Watching it after starting a print it probes exactly in the middle of the harmless holes all my non Bambu build plates have in the middle of their locating tabs.

Can I turn off build plate detection?

or

Is there a calibration file I can change so it probes just 1mm away from where it does now on the locating tabs. That way it could still have the plate detection safety check but allow the use of non genuine build plates

It’s very annoying that all these cheap but perfectly fine build plates now flag this warning, more than a few times my A1M has sat idle all day when I thought it was printing waiting for me to clear the warning message.

2

image
image1099×663 86.9 KB
maybe its because of the build plate Position detection, have you turned this setting off?

1 Like
3

If I made a build palte i would implement a copy of the official mark, then it would just work.

Of course, I do not make build plates so I know nothing about the commerical or legal factors involved.