As mentioned before, i tried a factory reset with the same firmware. It still does the “infinite” purge. Updated to the latest firmware, factory reset again, calibration done and… still does the same.
Reverting firmware versions does nothing. It’s a complete waste of material since i can confirm that the purge takes 3 to 6 minutes until it’s finished, and this is with Bambu Basic PLA.
@MakerWorld @BambuLab @SupportAssistant When will this issue be fixed? We are talking about much material for a simple purge. And it’s also dangerous because many times the nozzle gets covered in the purge material because there is no space for the material to go.