A1 nozzle scraping

Bambu Lab A1 Series Troubleshooting
1

Bambu Lab A1 with standard settings

After resolving a clog, the extruder has been giving a few errors.

i cleaned it as best i could.
Then i received a temperature sensor error and nozzle errors.

Then i cold pulled, cleaned the back some more, reset XYZ to home, and did multiple recalibrations.

Sensor is fixed, but i’m consistently getting a scraping nozzle with no error messages popping up.

PXL_20241206_135944309
PXL_20241206_1359443091920×2550 348 KB

PXL_20241206_171151811
PXL_20241206_1711518111920×2550 258 KB

PXL_20241207_001349525
PXL_20241207_0013495251920×2550 577 KB

PXL_20241207_024653968
PXL_20241207_0246539681920×2550 344 KB

PXL_20241207_031621652
PXL_20241207_0316216521920×2550 336 KB

2

Fixed this damn thing. Prints aren’t 100% but it’s fine tweaking from here on out, more like 95%. With that 5% potentially leading to the first layer completely lifting up