I may be going mad but I’m sure this used to be the same as PLA at 21mm^3/s volumetric limitation?
This is when selecting ‘Bambu ABS’ for filament type.
Is anyone printing faster than 16mm3/s?
I may be going mad but I’m sure this used to be the same as PLA at 21mm^3/s volumetric limitation?
This is when selecting ‘Bambu ABS’ for filament type.
Is anyone printing faster than 16mm3/s?
Probably quite a lot depending on their temperatures - I’m printing TPU faster than that.
Although ABS can print well but still warp more from residual stresses if it’s printed fast, might be why it’s set relatively low.
Run your own calibration with OrcaSlicer and know for sure what works best with your printer and settings.