ABS Actually Lifts Engineering plate from bed! Ideas?

[NeverDie]

@george.drapac

As you know, you really need a low profile clip to “keep it out of the way”

As a guard against collision, I did some experiments recently and proved to myself that it can be done with tape,

Super simple DIY garolite G10 build plate for X1C

Background: This thread actually starts on a different thread: Lightyear 3D Magnetic Build Plates for Bambu Lab Printers - #28 by NeverDie However, because it evolved in a direction that was different from the topic of that thread, I’m continuing it here rather than there. What’s new since then: I washed the G10 with Dawn while scrubbing it with a blue Scotch Brite, as suggested by others on that thread. Then I adhered adhered the G10 build plate directly to the heated bed using 5 small str…

though more as a short-term stopgap measure and probably not a good long-term solution.