Agressive warping - plate warping too

[fabrica3D]

Hi guys. How are you? I am Leo, from Brazil. After a lot of money expedend, a lot of credit card limits exceededs, I finally have bought three X1C printers. Here in Brazil it coasts a 16,000 brazilian real. It is almost a year of salary to buy each printer. Yeahhh, it sucks to live in this place…

Well, lets get to the point. I am having a lot of warping using ABS, PC and PA (nylon). I tried a lot of things: I raised the temperature of bed. I tried to heat chamber 30 minutes (until 51 celcius) before printing… Used a better glue. Then I remove the Cool Plate and the turn the Enginnering plate thinner. I used some printed clips to hold the plate on heated bed… Nothing… I tried everything that I saw on the foruns, facebook and so on… And… For large pieces of ABS, PC and PA it is impossible to print.

I tried with Enginnering plate, Cool plate, High temp plate and black Pei plate. I don’t tried with gold pei, because didn’t arrived here in Brazil yet…

Someone has tried another advanced tecnique?

[3dsurfr]

Welcome here! See Large ASA prints warping which has info not necessarily limited to ASA.

You didn’t mention any settings you’re using. Have you tried a raft? How do you let things cool off, etc.

Something to consider is carbon fiber or glass fiber infused filament. Not for the strength but for the reduced warping. I know it costs more…

I’ve been contemplating a glass plate, but I think in the end one has to figure out how to relieve the stresses during printing otherwise they will do that over time afterwards somehow.