AMS 2 Pro Drying

Bambu Lab AMS AMS 2 Pro
1

Ok, I know this has been discussed but I didn’t see anything about it before placing my P1S Pro Combo purchase.

How friggin annoying is it that I have to use the printers control panel to start and stop drying???

Like, it’s already fully networked and reports its drying status and environmental data to Handy and Studio, so… Let me start and stop it remotely lol

Everytime I remember, “hey, I should check the humidity of the AMS” and then realize it’s a little higher than I’d like, I then have to get up and go to my printer to hit dry.

And considering my ADHD brain just says “do it later”, I never do it :joy:

I love the other functionality and build of the AMS 2, but this is such a basic piece of functionality to have missed.

Rant over lol

1 Like
2

Agreed, I have my gear setup on a smart plug and I can turn that off instead. The AMS does not resume drying after a power cycle.

This does nothing for allowing me to start the drying but at the same time, if I am staring a drying cycle I am inserting/removing spools anyway and securing the filement so starting from the printer is less of an issue IMO.

I would like a stop function in Bambu Studio, as I sometimes Do a quick 30/60min heat cycle to push out any extra humidity gained from a lid open.